English-102
REPAIR INSTRUCTIONS
Replacing the switch for driver’s seat
1. Pull apart the connector under the
driver's seat and release the shock
absorber from the chassis.
2. Remove the driver’s seat.
3. Remove the seat cushion from the
underframe.
4. Remove the switch from the seat
cushion.
5. Remove the switch from the cable. The
connector is locked by a plastic catch.
6. Assemble in reverse order.
Sensors
The function of the sensor can be tested with
the LED, which is integrated in the sensor.
• Hydrostatic control (drive pedals)
• Parking brake, see page 101
• Lifting arm
• Differential lock pedal
Sensors are not sold separately. Replace the
cable harness with the four sensors when a
fault has been established.
Set the distance 2-3 mm between the sensor
and its target surface. Tightening torque
30 Nm.
8043-111
Driver’s seat switch
8043-171
LED in sensor drive pedals
IMPORTANT INFORMATION
The sensors only permit a 200 mA load.
Do not use a test lamp for testing.
8043-137
Sensor lifting arm
8043-175
Sensor diff lock pedal
IMPORTANT INFORMATION
The sensor has a thin wall with a fine thread
and the thread strip if tightened too tight.
To Next Page
Loading...
