English-120
REPAIR INSTRUCTIONS
Replacing the lift cylinder
1. Open the cover on the chequered floor
plate. Remove a circlip and knock out
the axle for the front mounting.
2. Jack up and block the machine
3. Place a container under the cylinder to
collect the waste oil.
4. Clean according to the general
instructions.
5. Release the hydraulic lines from the
cylinder. Fit protective plugs.
6. Remove a circlip and knock out the axle
for the rear mounting. Remove the
cylinder.
7. Assemble the cylinder in the reverse
order. Tightening torque for hydraulic
lines as set out in the table.
8. Fill with hydraulic oil if necessary.
9. Start the engine and run the cylinder to
its end positions to bleed.
10. Check for leakage.
11. Top up the hydraulic oil if necessary.
Replacing the steering cylinder
1. Jack up and block the machine so that
the rear axle can swing.
2. Place a container under the cylinder to
collect the waste oil.
3. Clean according to the general
instructions.
4. Release the hydraulic lines from the
cylinder. Fit protective plugs.
5. Remove the screws in the linkage
bearing the both mountings.
6. Remove the upper part of the cylinder
mountings (model year 2006 - 2007) and
lift off the cylinder.
7. Assemble the cylinder in the reverse
order. Tightening torque for screws and
hydraulic lines as set out in the table.
8. Fill with hydraulic oil if necessary.
9. Start the engine and run the cylinder to
its end positions to bleed.
10. Check for leakage.
11. Top up the hydraulic oil if necessary.
To Next Page
Loading...
