Husqvarna PT26D - Lights

English-103
REPAIR INSTRUCTIONS
Lights
Replacing the headlight bulb
Applies to the headlight lamp.
For information about the bulb type, see
“Technical data”.
1. Remove the plastic covers (41+43)
around the steering wheel console.
2. Disconnect the cable (Caution plastic
hooks) and carefully lift off the unit with
warning lamps (39).
3. Remove the headlight console (34) from
the steering wheel console, 4 x screws.
(If the headlight insert is removed from
its mounting frame, the headlight must
be realigned.)
4. Disconnect the electrical terminal from
the bulb.
5. Fold the wire loop for headlight lamp to
one side and replace the bulb.
6. Assemble in reverse order.
Light setting
Place the machine at least 5 m from a wall.
The machine must stand flat.
The steering wheel console must be in the
rear position
Switch on the headlights.
The low beam's upper limit line must fall
1 cm for each metre distance to the wall,
measure from the centre of the headlight.
Adjust with the screws (36) if necessary.
These are accessible once the rear plastic
cover around the steering wheel console has
been removed.
8043-130
Headlight parts
IMPORTANT INFORMATION
When the plastic covers are removed, the
unit with warning lamps is released. Do not
damage it.
IMPORTANT INFORMATION
Do not touch the bulb glass with your
fingers. Finger prints evaporate and mark
the reflector.
IMPORTANT INFORMATION
When the plastic covers are removed, the
unit with warning lamps is released. Do not
damage it.