Husqvarna PT26D - DELIVERY AND DEALER SERVICE

English-16
SPECIFICATIONS
Tightening Torques
Knife bolts, belt pulleys on the cutting unit 75-80 Nm
Induction sensor (sensors) 30 Nm
Muffler clamping screws 20 Nm
Axle arm lift arm bearing 200 Nm
Screws and nuts, general tightening torque with zinc plated threads +
5%
Spanner size Allen key Thread Tightening Torques Note
8 mm 4 mm M5 6 Nm
10 mm 5 mm M6 10 Nm
-- 3 mm M6 10 Nm Lock/stop screw
13 mm 6 mm M8 24 Nm
-- 4 mm M8 18-20 Nm Lock/stop screw
17 mm 8 mm M10 47 Nm
17 mm - M10 12.9 70 Nm Drive disc on flywheel
18-19 mm 10 mm M12 81 Nm
30 mm - M20 200 Nm Lift bolt
Hydraulic hoses, coupling nuts, T-pipe +
5%. Counterhold required.
Spanner size Thread Tightening Torques Note
17 mm 9/16" ORFS 15 Nm Control unit
19 mm 9/16" JIC 35 Nm
22 mm 3/4" JIC 60 Nm
22 mm 9/16" ORFS 25 Nm Control unit
27 mm 7/8" JIC 85 Nm
Hydraulic connecting nipples in material +
5%
Spanner size Thread Tightening Torques Note
17 mm 7-16"-20 UNF 20 Nm Pump
19 mm 9/16"-18 UNF 25 Nm Aluminium/steel Block/block
27 mm G 3/8" 50 Nm Pump working hydraulics
27 mm G 1/2" 55 Nm Radiator
27 mm 7/8"-14 UNF 55 Nm Steel
32 mm 1.1/16"-12 UNF 60 Nm Aluminium block