English-58
DESIGN AND FUNCTION
Cutting unit with suspension
The cutting unit’s drive is described under “Transmission”.
Husqvarna PT 26D is equipped with a front mounted cutting unit to also mow in confined areas efficiently.
The machine is supplied with cutting unit Combi 132 or Combi 155. Combi 155 can be side shifted approx-
imately 8 cm (3.1/8") in relation to the machine.
Older types of cutting unit cannot be attached.
The Combi unit functions as a BioClip unit when a BioClip plug is fitted, but can be changed to rear ejection
by removing the BioClip plug.
In order to provide good accessibility for cleaning, repair and servicing, the unit can be set in the service
position. The service position means that the unit is raised and locked in the vertical position.
The Cutting Unit Components
A. Pin
B. Link joint
C. Cutting unit mountings
D. Cutting height settings
E. Propeller shaft with quick couplings
F. Service handle
G. Drive belt with cover
H. Angle gear
8009-777
Combi 155
8009-892
Combi 132
8009-289
Removal of BioClip Plug
8009-765
Service position
8009-759
The Cutting Unit Components
To Next Page
Loading...
