Husqvarna PT26D - Service Schedule

English-19
DELIVERY AND DEALER SERVICE
Service Schedule
The following is a list of maintenance procedures
that must be performed on the rider. Most of the
points that are not described in this workshop
manual are found in the operator’s manual.
= Described in this workshop manual.
= Not described in this workshop manual or the
operator’s manual.
= Described in the operator’s manual.
Maintenance Page Daily main-
tenance
Weekly
main-
tenance
Maintenance interval hours
Check for fuel and oil leaks - 
Check the safety switch, seat 101 
Check the safety switch, pedal system 101 
Check the engine oil level (at every
refuelling)
67 
Check the hydraulic oil level 109 
Check the coolant level 29 
Check / clean the engine’s radiator air
intake, the radiator screen and radiators
65  
Check fastenings (screws, nuts, etc.) - 
Start the engine and blades, listen for
unusual sounds
- 
Clean under the cutting unit and belt
covers
-
 
Check for damage - 
Check the air pressure in the tyres
(100 kPa)
91 
Clean thoroughly around the engine - 
Clean thoroughly around the
transmission
- 
Lubricate according to the lubrication
chart
3)
-

Clean the air filter and empty the
particle trap
72 
Check the blades 96 
Change the engine oil and filter
1)
67 
Replace hydraulic oil filter
4)
and
check the oil level
111 
Check the tension and condition of
the belts (alternator belt, power take-
off belts, cutting unit belt)
69
84
95

before after
500 1000 2000 3000250