Husqvarna PT26D - The Cutting Units Service Position

English-90
REPAIR INSTRUCTIONS
The Cutting Unit’s Service Position
In order to provide good accessibility for
cleaning, repair and servicing, the unit can be
set in the service position. The service posi-
tion means that the unit is raised and locked
in the vertical position.
Placing in the Service Position
1. The cutting unit must be in the lowered
position and the engine off.
.
2. Disconnect both quick couplings for the
propeller shaft under the service hatch
and remove the propeller shaft.
3. Start the engine and raise the cutting
unit to the transport position.
4. Stop the engine.
5. Remove the pins on both sides.
6. Tilt the cutting unit.
7. Secure the cutting unit with the pin in the
service handle.
8. The cutting unit in the service position.
Releasing the Service Position
Images, see “Placing in the service position”.
1. Remove the pin from the service handle
and lower the cutting unit.
2. Install the pins on both sides.
3. Lower the cutting unit to the mowing
position.
4. Fit the propeller shaft. The propeller
shaft only fits one way. Close the service
hatch and assemble the screw.
8009-765
Service position
WARNING!
Never leave the propeller shaft on
the machine with one end detached.
If the engine starts, damage might
occur.
8009-762
Propeller shaft
8043-050
Right-hand side pin
8043-054
Securing in the service position