English-89
REPAIR INSTRUCTIONS
Replacing the lifting arms and bushings in the lifting system
1. Remove the cutting unit, see “Side shift-
ing the cutting unit” on page 87.
2. Remove the floor plate.
3. Remove the front wheels.
4. Remove a circlip (15), knock out the
axle (14) and release the lifting cylinder
from the member.
5. Remove the nuts (11) and knock out the
lifting bolts (10). Model year 2008 has
two plastic washers as axial bearings.
6. Replace the bushings (6) in the arms and
the flange bushings (2) in the member.
7. Before assembling lubricate with molyb-
denum disulphide grease.
8. Caution: Risk for incorrect assembly, the
lifting arms (4) and (5) are turned so that
the brackets for the pins (9) point
upwards/outwards. Lift up the
member (1) with the lifting arms (4)
and (5) and fit the lifting bolts (10).
9. Assemble the nuts (11), tightening
torque according to the table.
10. Assemble remaining parts in the reverse order.
WARNING!
Warning heavy parts are released.
To Next Page
Loading...
