Husqvarna PT26D - Dismantling the Rear Axle

English-76
REPAIR INSTRUCTIONS
Dismantling the rear axle
1. Jack up and block the machine under
the frame.
2. Remove the rear wheels.
3. Place a container under the valve block
transmission.
4. Clean according to the general instruc-
tions.
5. Drain the hydraulic tank if sealing plugs
for the hydraulic lines are not available.
6. Connections can be interchanged. Mark
the hydraulic hoses so that they are
reassembled on the correct connections.
7. Release the hydraulic hoses for the rear
axle from the elbow nipples under the
valve block transmission. Fit sealing plugs
to prevent leakage and contamination.
8. Remove the clamp for the hydraulic
hoses.
9. Remove the four screws (20+21) holding
the pendulum shaft (19) in the rear
axle (22) and pull out the pendulum
shaft.
10. Caution: The rear axle is heavy. Pull the
rear axle backwards and lift it down.
8043-200
Rear axle attachment
8043-133
Pendulum shaft screws
8043-132
Jacking up