Husqvarna PT26D - Hydraulic Test Equipment

English-10
SPECIAL TOOLS
Hydraulic test equipment
Manometer
1 x manometer 0-2.5 MPa (0-25 bar)
1 x manometer 0-25 MPa (0-250 bar)
Alternatively, 1 x combination manometer with the above measuring ranges.
The manometers should be equipped with a measuring coupling with appropriate quick coupling with
thread M16x2 and 1 mm manometer hose
Measuring nipple kit
Tightening torque see “Hydraulic hoses, coupling nuts, T-pipe + 5%. Counterhold required.” on page 16.
and “Hydraulic connecting nipples in material + 5%” on page 16..
For measuring point P1: 7/16” UNF-20 in
axial piston pump and M16x2-DKLO for
manometer connection. Intermediate
coupling thread M14x1.5.
For measuring point P2: 9/16” JIC for T-pipe
and M16x2 for manometer connection.
For measuring point P3, P4, P5 Q2: 9/16”
UNF-18 in flushing valve and M16x2-DKLO
for manometer connection. Intermediate
coupling thread M14x1.5.
For measuring point Q1: 9/16” JIC
and steel plug 9/16” JIC inner thread.
8043-240
Nipples for measuring point P1
8043-241
Nipples for measuring point P2
8043-242
Nipples for measuring points P3, P4, Q2
8043-243
Nipples for measuring point P5
IMPORTANT INFORMATION
ENVIRONMENTAL HAZARD, Avoid spill-
age during hydraulic measurements.
Waste oil shall be treated as environmen-
tally hazardous and turned in to the work-
shop or other designated area for disposal.
Avoid skin contact; wash with soap and
water in case of spills.