English-79
REPAIR INSTRUCTIONS
Replacing the parking brake lock
cable
Model year 2007 - 2008
1. Remove the parking brake lock cable
and unhook the cable from the lock.
2. Remove the cable handle.
3. Remove the upper nut and pull the wire
downwards.
Older machines lack star washers.
506 48 87-01, whose task is to prevent the
cable from rotating when the upper nut is
tightened. Older machines should be modi-
fied. On newer machines, the star washer is
transferred to the new cable.
4. Thread on the clutch nut on the new cable.
5. Thread on the star washer on the new
cable.
6. Lock the star washer and clutch nut, size
11 mm as illustrated.
7. Assemble all parts in the reverse order.
Replacing the parking brake lock
Model year 2006
1. Remove the floor plate.
2. Remove the plastic panel covering the
circuit board.
3. Remove the two screws (78) holding the
complete lock.
4. Remove the entire lock.
5. If necessary, take apart the lock by
unhooking the spring (59) and removing
the screw (57).
6. Assemble in reverse order.
8043-208
Locking position star washer and clutch nut
8043-209
Parking brake model year 2006
To Next Page
Loading...
