English-59
DESIGN AND FUNCTION
The hydraulic lifting cylinder's (13) piston rod
is connected to a lateral member (1), which
has two forward facing lifting arms (4+5) with
attachment arms (3).
The cutting unit is suspended at the rear
edge in the two attachment arms with link
joints and pins. At the front are two swivel
castors.
An electro-hydraulic function gives a weight
transfer to the machine, to reduce the ground
pressure of the attachment.
The mowing height setting is made using
three knobs, two at the front and one at the
back.
The tilt angle is adjusted using an adjuster
screw on the right-hand side of the cover.
8043-047
Mowing height settings
8009-787
Adjustment screw tilt angle
To Next Page
Loading...
