English-159
APPENDIXES
J30: Connection for the horn. (HORN) (Traffic kit) / Cable harness 544 88 76-01 Brown + blue wires.
J31: Connection for the switch to signal (HORN SWITCH). 544 31 26-01
J32: Connection for +12 volt in to the circuit card. Pins 1, 2 and 3 lead in +12V. Pins 5 and 6 are negative in
to the card (12V POWER IN) / Cable harness 544 36 98-01. 6 way connector.
J34: Connection for engine; glow plug, starter motor, cooling fan, injection pump (MOTOR CONTROL)
/ Cable harness 544 32 21-01. 6 way connector.
J35: Connection for main relay, that connects the voltage to the circuit card and starter motor
(BATTERY SWITCH) / Cable harness 544 36 98-01 Red + blue wires.
J36: Connection for the alternator's charge regulator (ALTERNATOR R+L) / Cable harness 544 32 22-01
Red + brown wires.
J38: Voltage out to extra equipment, voltage is only available when the engine is running, fuse protected
with the fuse FU5.
(EXTRA POWER 1) / Cable harness 544 45 32-01 Red + blue wires. Used with the extra hydraulic kit
to provide voltage to the power outlet on the hydraulic take-off, can be used for extra lights on the
plough.
J39: Connection for the switch in the driver's seat (SEAT SWITCH) / Cable harness 544 32 30-01
Greenwire.
J40: HIGH SPEED SWITCH 544 31 24-01
J45: Connection for the rotating warning light (Traffic kit). (HAZARD LIGHT) / Cable harness 544 88 76-01
White + blue wires.
J46: Connection for the switch to the rotating warning light (Traffic kit). (HAZARD FLASH LIGHT SWITCH)
544 31 22-01
J47: Negative connection for the fan and injection pump (GND) / Cable harness 544 32 21-01 Blue wire.
J48: Theft protection, fitted at the rear of the circuit card (accessory).
J49: Voltage out to extra equipment, voltage is only available when the engine is running, fuse protected
with the fuse FU7.
(EXTRA POWER 2). +12V on pin 1 and GND on pin 2. Pin 1 is uppermost towards the top edge of the
circuit card.
To Next Page
Loading...
