English-26
DESIGN AND FUNCTION
Husqvarna PT 26D can be equipped with cutting unit, Combi 132 with a 132 cm cutting width or Combi 155
with a 155 cm cutting width. Cutting unit Combi 155 can be side shifted 8 cm (3 1/8") or mounted centrally
in relation to the machine. Combi 132 can only be mounted centrally.
The cutting unit is driven by two v-belts, a
power take-off shaft and a propeller shaft
from the engine. It is engaged by an electro
magnetic clutch, which is located in front of
the engine’s flywheel.
If necessary, the cutting unit can be turned to
the service position to be able to clean the
underneath of the cover for example.
To Next Page
Loading...
