English-34
DESIGN AND FUNCTION
Cutting unit drive
The cutting unit is driven by two v-belts, a
power take-off shaft and a propeller shaft
from the engine.
It is engaged by an electro magnetic clutch,
which is located in front of the engine’s fly-
wheel.
The power take-off shaft is supported with
two bearings in the chassis. The power take-
off shaft’s pulley and bearings are both fixed
in the shaft with two locking screws each.
The propeller shaft has two joints with quick
action couplings and is connected to the
angle gear on the top of the cutting unit.
The power take-off shaft’s bearing and the
propeller shaft’s joints are lubricated with
lubricant spray.
8043-185
Cutting unit drive
1. Angle gear
2. Propeller shaft
3. Front bearing
4 Power take-off shaft
5. Belt adjuster wheel
6. Drive belts
7. Electro magnetic clutch
8. Belt tensioner
9. Rear bearing
To Next Page
Loading...
