English-68
REPAIR INSTRUCTIONS
Replacing the engine’s oil filter
1. Remove the oil filter. If necessary, use a
filter remover.
2. Clean the oil filter’s mounting.
3. Wipe new, clean engine oil onto the seal
for the new filter.
4. Mount the filter by hand with + 3/4 turn.
5. Run the engine warm, then check that
there are no leaks around the oil filter
seal.
6. Check the oil level in the engine, top up if
necessary. The oil filter holds 0.2 litres of
oil.
WARNING!
Risk of spray and burn injuries. The
engine’s oil filter may be very hot
immediately after stopping. Allow
the engine to cool somewhat first.
8009-801
Engine oil filter
IMPORTANT INFORMATION
Replaced filters must be deposited with
assigned places for correct disposal. Avoid
skin contact; wash with soap and water in
case of spills.
To Next Page
Loading...
