HUST CNC H6D-B3 MANUAL
44
Setting by engineer.※
33. The basic point of Y-axis HOME direction Format：□□□.□□□ (Default = 0.000)
The setting means that after executing HOME, the distance of moving alone the
direction to HOME. Then the HOME signal input in the controller.
Setting by engineer.※
34. The calculation of Y-opening default Format：□
Setting=0 The bigger Y-axis’ coordinate is set, the more bending angle is
executed.
Setting=1 The smaller Y-axis’ coordinate is set, the more bending angle is
executed.
This setting factor is set by engineer before selling. So, any change of this
setting will effect the location of Y-axis very critically.
Setting by engineer.※
35. The mode after Power-On Format：□
Show the page when Power-On
The value = 0 AUTO MODE
The value = 1 JOG MODE
The value = 2 HOME MODE
To Next Page
Loading...