HUST CNC H6D-B3 - Page 84

HUST CNC H6D-B3 MANUAL
78
ERROR-53
Message:
The machine coordinate of Y(D)-axis>The setting of software program-pos. OT +.
Recommended Remedy:
Ascertain the value of Parameter page 2『Software Program-Pos. OT +』.
ERROR-54
Message:
The machine coordinate of Y(D)-axis<The setting of software program-pos. OT－.
Recommended Remedy:
Ascertain the value of Parameter page 2『Software Program-Pos. OT－』.
ERROR-55
Message:
The machine coordinate of Z(R)-axis > The setting of software OT+.
Recommended Remedy:
Ascertain the value of Parameter page 1『Software OT+1』.
ERROR-56
Message:
The machine coordinate of Z(R)-axis < The setting of software OT－.
Recommended Remedy:
Ascertain the value of Parameter page 1『Software OT－1』.