4--7
27
Machine installation
" Power up the machine by turning the main switch on the left hand side of the
base (the control console should illuminate);
Check that the motor is rotating in the correct direction. For this check the
following operations must be carried out:
" set the blade tension to 1200 BAR;
" make sure the cover is properly closed: at the back of the cutting head there is
a bayonet limiter for correct cover closure;
" make sure that the machine is not in an emergency condition (red mush-
room---head pushbutton released);
" after having applied voltage to the machine, set the selector for permission of
motor s tart up to 1;
To Next Page
Loading...