HYDACELECTRONIC ENS 3000 - Changing Main Programming Enable

ENS 3000 Page23
Status 21.08.2015 HYDAC ELECTRONIC GMBH Part No. 669850
11.2 CHANGING THE MAIN PROGRAMMING ENABLE
NOTE:
Switch off the supply voltage or disconnect the instrument from the supply
voltage.
NOTE:
• Whenever any settings have been altered, "ProG" appears briefly in the
display when the display switches over. The new setting is then saved in the
unit.
Press both arrow keys
simultaneously
and hold them down.
Switch on supply voltage.
(hold the keys down for
3 s)
Display
(release
arrow keys)
FrEE = programming enabled
Loc = programming disabled
→

3s
→

0s
HYDAC
mode
?
?
HYDAC
mode
?
?
Use the or keys to alter the
settings
3 s
Pressure display
(Data not changed)
3 s
Pressure display
(Data changed)
ba
r
3
s
Fluid level indication
Fluid level indication