111
4. System Setup
-This setting to ensure the accuracy to feed the
bar to part off position.
NOTE: Replacing of new measuring sensor,
should reset the position of measuring sensor
again under : “SENSOR POSITION SETTING”
(1) Key in :
- T: Length of test bar ( min : 300mm)
- Ø: Diameter of teat bar (Ø8mm to Ø80mm)
(2) Press “ OK “
(1) Load the test bar on the bar rack .
(2) Press auto start
Note: If no test bar on bar rack,
Alarm 3 (No material) appear.
Indicate previous bar length measuring sensor
position
To Next Page
Loading...
