116
4. System Setup
4.15 Maintenance
-you can set the value for maximum loading
cycle
-Setting range : 0 to 9999
-Factory setting : 2000
When the barfeeder loading value
reaches to the setting value, the next
power on you will see " !! : 12 Please
Grease ball screw" .
(1) You will have 5 times to postpone
greasing ball screw. After 5 times, the
Postpone button will disappear.
(2) Reset : you need to grease ball
screw and the setting value of loading
cycle will be recalculated
To Next Page
Loading...
