Hydrafeed MSV 80 - System Parameter List

171
10. Parameter List
10.2 System Parameter List
1. Bar feeder alarm
[ ﹀ ]
2. M code finish (Feeding)
[ ﹀ ]
Normally bar end
signal
[ ]
3 Bar end
[ ﹀ ]
Bar end signal
latch until part off
position
[ ]
4. Bar feeder AUTO MODE [ ]
Bar feeder
to CNC
lathe
signal
5. M-FIN (OPTIONAL) [ ]
1. Chuck open
[ ﹀ ]
2. M code (feed command) [ ]
Start bar feeder in
CNC auto mode
[ ]
3 CNC auto mode [ ]
After bar feeder
ready CNC send
auto mode
[ ]
normally close [ ]
4. CNC emergency
stop
[ ]
normally open [ ]
CNC lathe
to Bar
feeder
signal
5. M code (optional) [ ]
Bar feeder stop
completely
[ ]
1
INTERFACE
SIGNALS
SELECTION
Interface
signal
optional
function
selection
Changing CNC AUTO to MANUAL
mode while bar feeder in auto
cycle
Bar feeder waiting
CNC auto mode
to continue
[ ]
A Length of flag motion mm
B Length for slow pushing mm
C Length for flag going back slowly mm
2
Carriage
position setup
D
Length for pushrod going back
slowly
mm
Loading up position (5mm) mm
Pull rod length mm
3 Loading position setup
Loading down position(X axis) mm