Hydrafeed MSV 80 - 3.2.2 Bar diameter Setting; 3.2.3 Material Selection

22
3. User Setup
3. User Setup
3.1 User Setup Introduction
`
1.Bar type / Diameter
3.position setup
4. Feeding type
1. Sub spindle pull
2. Barfeedin
g
with / without turret
3. Multi
p
le fed com
p
onents
4. Feeding against moving turret
1. End of bar position
2. Part off Position
3. pushrod retract position
4. Material selection
5. Push torque adjustment
1. Bar type
2. Bar diameter
3. The number of times for trying
push new profile bar pass
through the chuck
2.Component length
5. Back stop
6. Shaft load
7. Chucking mode