136
7. Alarm List
Alarm
No.
Alarm Picture Cause Action
36
Push bar too long.
When new bar goes to
part off with turret
position , barfeeder send
M code finish signal to
lathe , then turret is
moving , but the pushrod
is moving over the
spindle length
Check CNC program
(on 4.8)
37
Pushrod can’t return to home
position
When start barfeeder
auto cycle ,Pushrod
can’t go back to
reference position .
1. Check that something is
not keeping hold of
pushrod.
2. Check
Reference switch
(LS-1)
38
(Normal barfeeding jobs)
EOB value setting too long
When you select normal
feeding jobs function ,
Pushrod push the bar
over than S value
(spindle length),
Setting
EOB (End of bar position )
= S value(spindle length)
– W value(component
length)
To Next Page
Loading...
