142
8. Warning List
Warning
No.
Warning Picture Cause Action
13A
Impossible to start auto cycle with
CNC feed command.
CNC with M code (feed
command). You can’t
start auto cycle.
(when you select chuck
close bar check)
-Touch on <NEXT>.
-Cancel M code
-Feed bar manually to CNC
and close the chuck.
14
.
Wrong selection on part
off function of using
turret or without turret.
Note: Hexagon bar with
inching function must
use turret.
Select part off function with
turret function ( on 3.11.1 )
or change the bar type to
round bar ( on 3.2.1 )
15
Wrong selection on
ejecting remnant by
using new bar or
pushrod
Note: Turret will
obstruct the ejecting of
remnant.
Select eject remnant by
pushrod.(on 3.11. 2)
To Next Page
Loading...
