43
3. User Setup
2.Multiple fed components lathe job program (Duble spindle) feeding with turret + Sub spindle pull
If interface select
Chuck open
M code (feed command)
Eject new bar with turret :
(Main program)
Turret come to position 1 ( 20mm
position )
Chuckopen
M code(feed command)
Chuck close
Cutting (1)
Sub spindle Chuck open
Sub spindle go to correct position
Sub spindele Chuck close clamping the
bar
Chuck open
sub spindele pull bar to position
2( 80mm position)
M code(feed command)
Chuck close
cutting (2)
Pxx (Sub program)
Chuck open
M code (optionan) bar change
W – 100
(Turret come to loading
position)
M code (optionan) bar change
Chuck close
Part off
M99 ( go to main program
)
Pxx (Sub program)
Chuck open
M code(feed command)
W – 100
(Turret come to loading position)
M code(feed command)
Chuck close
Part off
M99 ( go to main program
)
To Next Page
Loading...
