Hypertherm Command THC User Manual

HT4001 SETUP
3d-4 CommandTHC for X-Y Table Instruction Manual
5
Power supply interface cable
See Figure 3d-2.
Connect the interface cable plug to the 1X6 receptacle on the back of the power supply.
Connect the other plug of the interface cable to the CNC.
Install the 3 pairs of wires of the interface cable to the plasma interface assembly as shown
in Figure 3d-2.
See Figure 3d-3 for the interface cable part numbers and signal list.

Hypertherm Command THC Specifications

General

Brand	Hypertherm
Model	Command THC
Category	Cutter
Language	English