8000 SRM 707 Maintenance Schedule
Table 1. Maintenance Schedule (Continued)
Item
No.
Item
8hr/
1day
250
hr/
6wk
500 hr/
3mo
1000
hr/
6mo
2000 hr/
1yr
Procedure or
Quantity
Specification
15
Mast
Sideshift Carriage
L 3Fittings Multipurpose
Grease
See NOTE 8
15
Mast
Integral Sideshift
Carriage
X C Check wear
4Bearings
2.5 mm (0.098 in.)
or less
20
Hydraulic Oil Filter C
1
See NOTE 2
See Parts Manual
8
Fuel Filter,
Gasoline and LPG
(Pre-2004)
C
1
See Parts Manual
Fuel Filter,
LPG (IMPCO)
C
LPG Regulator
(Aisan)
X Drain tar
LPG Regulator
(IMPCO)
X Drain Tar
Idle Circuit/Injector
Filter (Aisan)
C
X=Check C=Change L=Lubricate CIL=Check Indicator Light during operation
NOTE 1: Che
ck the fuel system for leaks prior to any service or maintenance activity.
NOTE 2: Change filters on NEW lift trucks at first 100 hours on hourmeter.
NOTE 3: Very dirty conditions require daily clean and check.
NOTE 4: Heavy-duty or high-temperature operations require more frequent checks.
NOTE 5: Cooling indicator light is used only on S40-65XM lift truck models.
NOTE 6: In dirty or dusty environments, replace at 1000 hours.
NOTE 7: Perkins engine is to be at operating temperature of 82 ±1.5 C (180 ±35 F) when inspecting for low
idle setting.
NOTE 8: Multipurpose grease with 2 to 4% molybdenum disulfide.
NOTE 9: Mazda M4-2.0G and M4-2.2G 2004 or newer engines, check at 5000 hours or 7 years.
NOTE 10: Replace on Mazda M4-2.0G and M4-2.2G engines every 2500 hours. Use only hour interval.
NOTE 11: On Mazda M4-2.0G and M4-2.2G engines, replace the timing belt every 3500 hours. Use only the
hour interval.
NOTE 12: Perform maintenance as specified by the manufacturer.
17
To Next Page
Loading...
