Maintenance Schedule 8000 SRM 707
Table 1. Maintenance Schedule (Continued)
Item
No.
Item
8hr/
1day
250
hr/
6wk
500 hr/
3mo
1000
hr/
6mo
2000 hr/
1yr
Procedure or
Quantity
Specification
Regulator Pressure/
Diaphragm and
O-ring (Aisan)
X C Check and adjust
per specification
if required
Replace if required
Solenoid Valve (Aisan) X Check and clean
if required
Fuel Filter (Aisan) X C
2
See Parts Manual
Low Emissions
System
Mazda LPG and GM
Aisan Closed Loop
CIL
11
Transmission Oil
Filter
C
1
See NOTE 2
See Parts Manual
2
Wheel Bearings
Drive Wheel (In-
ner)
L 1lb Multipurpose
Grease
See NOTE 8
2
Wheel Bearings
Steer Wheels
L As required Multipurpose
Grease
See NOTE 8
28
Coolant Hoses X Check
Condition
See Parts Manual
X=Check C=Change L=Lubricate CIL=Check Indicator Light during operation
NOTE 1: Checkthefuelsystemforleakspriortoanyserviceormaintenanceactivity.
NOTE 2: Change filters on NEW lift trucks at first 100 hours on hourmeter.
NOTE 3: Very dirty conditions require daily clean and check.
NOTE 4: Heavy-duty or high-temperature operations require more frequent checks.
NOTE 5: Cooling indicator light is used only on S40-65XM lift truck models.
NOTE 6: In dirty or dusty environments, replace at 1000 hours.
NOTE 7: Perkins engine is to be at operating temperature of 82 ±1.5 C (180 ±35 F) when inspecting for low
idle setting.
NOTE 8: Multipurpose grease with 2 to 4% molybdenum disulfide.
NOTE 9: Mazda M4-2.0G and M4-2.2G 2004 or newer engines, check at 5000 hours or 7 years.
NOTE 10: Replace on Mazda M4-2.0G and M4-2.2G engines every 2500 hours. Use only hour interval.
NOTE 11: O
n Mazda M4-2.0G and M4-2.2G engines, replace the timing belt every 3500 hours. Use only the
hour inte
rval.
NOTE 12: Perform maintenance as specified by the manufacturer.
18
To Next Page
Loading...
