11
4.7 Selecting a Zone and Channel (Conventioal)
In conventional mode, the radio receives and transmits data and voice on the selected channel. A zone
is a group of channels within the same operational area. To select a zone and then a channel contained
in it, do as follows:
Step 1 Select a zone in one of the following ways:
Go to Menu > Zone, and then select the required zone.
Press the preprogrammed Zone Up or Zone Down key.
Step 2 Select a channel in one of the following ways:
Rotate the Channel Selector knob.
Press the preprogrammed Channel Up or Channel Down key.
4.8 Registering with BS (Trunking)
Upon power-on, the radio automatically hunts the control channels to find an available BS for registration.
During hunting, the radio displays "Out of Range" with the icon
, the LED indicator flashes orange
slowly, and the radio emits the hunt tone.
The radio automatically registers with the found BS for communication. If you want the radio to register
with another BS, press the programmed Manual Current Hunt key to hunt again.
To Next Page
Loading...
Need help?
General
