23
automatically. In trunking mode, the radio displays
after the call is established successfully.
6.5.3 Ending Broadcast Calls
A broadcast call ends in any of the following cases:
The calling party ends the call.
The call duration exceeds the period preset by your dealer.
A preemptive or emergency call interrupts the call.
The base station signal is lost.
6.6 Include Call (Trunking Only)
An include call is a special group call initiated to another group in call hang time of an ongoing group call,
so that the group joins the ongoing call. Your radio can initiate an include call only after being authorized
by your dealer.
For operations of the include call, see "Group
Call".
6.7 Call on Analog Channel (Conventional Only)
You can initiate or receive a call on an analog channel with or without signaling.
6.7.1 Call Without Signaling
A call without signaling is a call initiated to all the other users on an analog channel without signaling.
To initiate a call without signaling, do as follows:
Step 1 Rotate the Channel Selector knob to select the required channel.
Step 2 Press and hold the PTT key, and speak into the microphone.
6.7.2 Call With Signaling
On an analog channel with signaling, you can initiate a call to a specific contact on the channel. Do as
follows:
Step 1 Rotate the Channel Selector knob to select the required channel.
Step 2 Press the OK/Menu key, and go to Contact > Contact List.
Step 3 Select the required contact.
Step 4 Press and hold the PTT key, and speak into the microphone.
To Next Page
Loading...
Need help?
General
