20
Mode Manner Operation
ReDial/Back
Dial Call Log
1. From the home screen, press or (if preprogrammed as the
ReDial or BackDial key).
2. Select the required phone contact from the list.
3. Press or press and hold the PTT key.
6.3.2 Receiving Phone Calls
Conventional Mode
When receiving a phone call, you need to transmit the preprogrammed connect code to access the
telephone system as described in 6.3.1 Initiating Phone Calls
After the radio accesses the telephone system successfully, the call is established automatically.
Trunking Mode
When you receive a phone call, the radio displays . To answer the call, press or press and hold
the PTT key within the preset period. After the call is established successfully, the radio displays
.
6.3.3 Ending Phone Calls
In conventional mode, a phone call ends in any of the following cases:
You transmit the preprogrammed disconnect code in the same way as the connect code.
The phone user hangs up.
In trunking mode, a phone call ends in any of the following cases:
The calling or called party ends the call.
The call duration exceeds the period preset by your dealer.
A preemptive or emergency call interrupts the call.
The base station signal is lost.
6.4 All Call
Conventional Mode
An all call is a call from an individual user to all other users on the current channel.
Trunking Mode
An all call is a call from an individual user to all other users in a specific BS, area, or system.
According to whether the called party can respond, an all call is classified into the following two types:
Broadcast All Call: The called party cannot respond to the call.
To Next Page
Loading...
Need help?
General
