21
General All Call: The called party can respond to the call.
To set the type, go to Menu > Settings > Radio Set > All Call, and then select Broadcast Call or
General Call.
6.4.1 Initiating All Calls
Your radio can initiate an all call only after being authorized by your dealer.
The following table describes how to initiate an all call in conventional mode and trunking mode.
Mode Manner Operation
Convention
al
Preset Contact
1. Rotate the Channel Selector knob to select the channel
associated with the all call contact.
2. Press and hold the PTT key.
Contact List
1. Go to Menu > Contact > Contact List.
2. Select the all call contact.
3. Press and hold the PPT key.
Trunking
Manual Dial
1. Go to Menu > Settings > Radio Set > Keypad Mode, and then
select Enable.
2. From the home screen, enter the all call number.
3. Press or or press and hold the PTT key.
ReDial Call Log
1. From the home screen, press (if preprogrammed as the
ReDial key).
2. Select the all call log from the list.
3. Press or press and hold the PTT key.
6.4.2 Receiving All Calls
When you receive an all call, the radio displays , and the call is established automatically.
6.4.3 Ending All Calls
In conventional mode and trunking mode, an all call ends when the Time-out Timer (TOT) expires.
In trunking mode, an all call also ends in any of the following cases:
The calling party ends the call.
The call duration exceeds the period preset by your dealer.
The base station signal is lost.
To Next Page
Loading...
Need help?
General
