16
Mode Manner Operation
2. Press and hold the PTT key.
Favorites
1. Go to Menu > Contact > Favorites.
2. Select the required group contact.
3. Press or press and hold the PTT key.
Subgroup
1. Press the preprogrammed Subgroup key or go to Menu >
Subgroup.
2. Select the required subgroup, and then select Member.
3. Select the required group contact.
4. Press or press and hold the PTT key.
Manual Dial
1. Go to Menu > Settings > Radio Set > Keypad Mode, and then
select Enable.
2. From the home screen, enter the group call number.
3. Press or or press and hold the PTT key.
ReDial/Back
Dial Call Log
1. From the home screen, press or (if preprogrammed as the
ReDial or BackDial key).
2. Select the required group contact from the list.
3. Press or press and hold the PTT key.
Call Log
1. Go to Menu > Call Logs > Outgoing/Incoming > Outgoing
List/Incoming List.
2. Select the required group contact.
3. Press or press and hold the PTT key.
6.1.2 Receiving Group Calls
When you receive a group call in conventional mode, the radio displays . The call is established
automatically. In trunking mode, the radio displays
after the call is established successfully.
6.1.3 Ending Group Calls
In conventional mode and trunking mode, a group call automatically ends when the call hang time
expires.
In trunking mode, a group call also ends in any of the following cases:
The calling party ends the call by pressing the End key or preprogrammed Clear Down key.
The call duration preset by your dealer expires.
To Next Page
Loading...
Need help?
General
