The table below lists the details of each test.
No.
Test Item
Standard for Judgement
Note
1 Software Version Test
Check whether the software version is
correct.
2 Rtc Test
The screen displays the clock after being
woken up.
"Rtc" indicates real-time
clock.
3 GPS Test
The radio finds GPS signals and displays
more than three active satellites and
signal quality.
The GPS transmitter must
be enabled to conduct
indoor test.
4 BT Test
The radio recognizes BT Mac addresses
and surrounding recognizable BT
devices.
There must be BT devices
around.
5 WLAN Test
The radio recognizes WLAN Mac
addresses and surrounding recognizable
WLAN signals.
There must be WLAN
networks around.
6 T Card Test
The SD card is inserted properly before
turning the radio on.
"T Card" indicates SD card.
7 G-Sensor Test
The value of each axis changes when the
radio is tilted or rotated.
"G-Sensor" indicates
gravity sensor.
8 E-ComPass Test
The compass points to the same direction
when the radio is rotated horizontally.
Sweep the radio in an
8-figure pattern before the
test.
9 L-Sensor Test
The test value follows the change of the
light intensity. When the light is
illuminated, the test value is greater than
50. When the ambient light sensor (the
right side of the front camera) is blocked
by hand, the test value is less than 5.
"L-Sensor" indicates
ambient light sensor.
10 P-Sensor Test
When the proximity sensor (the right side
of the front camera) is not blocked, the
test value is 5. When the proximity is
blocked by hand, the test value is 0. Then
"P-Sensor" indicates
proximity sensor.
To Next Page
Loading...
