MXT+ Hydraulic Torque Wrench Basic Operations Manual
8
DETERMINE REQUIRED DIRECTION OF ROTATION
For tightening, the square drive must be inserted so that “TIGHTEN” is visible when mounted on the application.
For loosening, the square drive must be inserted on the opposite side so that “LOOSEN” is visible when mounted.
. PREPARATION AND SETUP
INSPECT TOOL
• Check the calibration sticker to verify the most recent calibration date.
• Inspect cycle counter to ensure lens is fully seated and not cracked.
• Monitor cycle count to aid in scheduling calibration and preventative maintenance.
• Remove and inspect the square drive and ensure there is no damage to the inner or outer splines.
• Inspect the uniswivel and couplers for signs of damage or oil leaks. Leaking tools should not be used.
To Next Page
Loading...
