1
Instructions in this section are compliant with ISO-11148-6:2012 and ISO-12100:2010.
WARNING! Read all safety warnings designated by the
symbol and all instructions.
WARNING! Read all instructions before use. To reduce the risk of injury user must read manual.
A. GENERAL
• Employer Responsibility: The user’s employer shall assess the specific risks that can be present as a result of each use.
• Maintenance Instructions: General maintenance recommendations include care and handling instructions
(see Section 7).
• Special Markings on the Tool: There are no special markings or symbols on the tool.
• Residual Risks: When this tool is used for its intended purpose by trained individuals equipped with adequate
personal protective equipment according to the instructions in this document, there are no known residual risks.
• Statement of Use: The MXT+ Hydraulic Torque Tool is intended for use in tightening fasteners with controlled torque
in heavy duty industrial bolting applications.
• Trained User Only: This tool should be used only by fully trained personnel, and this document is written only for
trained professionals. This tool should not be used without proper training and supervision. Contact HYTORC for
additional training information.
B. GENERAL SAFETY RULES
• Maintenance must be performed by a qualified HYTORC technician.
• Operating the tool in any fashion other than as described herein can result in serious bodily injury and is
forbidden.
• For multiple hazards, read and understand the safety instructions before installing, operating, repairing,
maintaining, changing accessories on, or working near the tool. Failure to do so can result in serious bodily injury.
• Only qualified and trained operators should install, adjust or use the tool.
• Do not modify this tool. Modification of the tool invalidates the warranty and can reduce the effectiveness of safety
measures and increase the risks to the operator.
• Do not discard the safety instructions; give them to the operator.
• Do not use the tool if it has been damaged.
• Tools shall be inspected periodically to verify that the ratings and markings are legibly marked on the tool. The
employer/user shall contact the manufacturer to obtain replacement marking labels when necessary.
C. PROJECTILE HAZARD
• Failure of the workpiece, of accessories or even of the inserted tool itself can generate high-velocity projectiles.
• Always wear impact-resistant eye protection during operation of the tool. The grade of protection required should
be assessed for each use.
• Ensure that the workpiece is securely fixed.
. GENERAL SAFETY INFORMATION
To Next Page
Loading...
