MXT+ Hydraulic Torque Wrench Basic Operations Manual
12
INITIALIZE PUMP AND CHECK PRESSURE
NOTE: Always follow pump manufacturer’s guidelines and
instructions.
• Ensure that all components and connections are
compatible and have sufficient power.
• Check that voltage and frequency of main supply
outlet match information on the pump plate.
• Power-on pump and check that pressure builds to
10,000 psi in advance, 1,500 psi in retract.
• Air Powered Pump (optional): Verify air supply is 100
psi and 130 CFM.
DETERMINE PRESSURE REQUIREMENTS
• Tool Torque output is calibrated over a range of
hydraulic pressures. Select pressure necessary for
desired torque from the table provided.
• Adjust pump regulator to set the desired torque
output. NOTE: Always adjust regulator pressure UP,
not down.
1-800-FOR-HYTORC HYTO RC.COM
PSI BAR FT-LBS KGM Nm
1500 104 464 64 629
1600 110 496 69 672
1800 124 559 77 758
2000 138 622 86 843
2200 152 685 95 929
2400 165 748 104 1015
2600 179 812 112 1100
2800 193 875 121 1186
3000 207 938 130 1272
3200 220 1001 138 1357
3400 234 1064 147 1443
3600 248 1128 156 1529
3800 262 1191 165 1614
4000 276 1254 173 1700
4200 290 1317 182 1786
4400 303 1380 191 1871
4600 317 1444 200 1957
4800 331 1507 208 2043
5000 345 1570 217 2128
5200 358 1633 226 2214
5400 372 1696 235 2299
5600 386 1759 243 2385
5800 400 1822 252 2470
6000 414 1885 261 2555
6200 427 1948 269 2641
6400 441 2011 278 2726
6600 455 2074 287 2812
6800 468 2137 296 2897
7000 482 2200 304 2982
7200 496 2262 313 3067
7400 510 2324 321 3151
7600 524 2387 330 3235
7800 538 2449 339 3320
8000 552 2511 347 3404
8200 565 2572 356 3487
8400 579 2634 364 3570
8600 593 2695 373 3654
8800 607 2757 381 3737
9000 620 2818 390 3820
9200 634 2878 398 3901
9400 648 2938 406 3982
9600 662 2997 415 4063
9800 676 3057 423 4144
10000 690 3117 431 4225
HYTO RC STANDARD TORQUE CHART
Tool Model: MXTP-03
Pressure and Torque Conversion Chart
SAMPLE TORQUE CHART
INSTALL HANDLE
• Installation and use of the tool handle ensures maximum safety when handling the tool.
• Simply thread the handle into the tool with the twist knob on top until firmly attached.
• Partially unscrew knob to rotate handle to desired position after the tool is mounted.
To Next Page
Loading...
