IBM 7212 102 User Manual

Step 22 (AS/400 or iSeries Only)
This step verifies whether the installed devices can communicate with the AS/400
or iSeries host system.
1. At the command line on any AS/400 or iSeries menu, type
strsst
then press Enter.
2. At the System Service Tools (SST) screen, type 1 (Start a service tool), then
press Enter.
3. At the Start a Service Tool screen, type 7 (Hardware service manager), then
press Enter.
4. At the Hardware Service Manager screen, type 2 (Logical hardware resources),
then press Enter.
5. At the Logical Hardware Resources screen, type 1 (System bus resources), then
press Enter.
6. In the Description column of the Logical Hardware Resources on System Bus
screen, locate the input/output processor (IOP) device (the SCSI controller) to
which the 7207 Tape Drive is attached. Type 6 (I/O Debug), then press Enter
(refer to ″Performing the Checkout Procedure,″ in the 7212 Model 102 Storage
Device Enclosure Setup and Operator Guide).
7. At the Select IOP Debug Function screen, type 4 (IPL I/O processor), then press
Enter twice. The host system performs an initial program load (IPL), refreshes
its settings, and displays the message Re-IPL of IOP was successful.
8. After the IPL completes, press F12 to return to the Logical Hardware Resources
on System Bus screen.
9. In the Description and Type-Model fields of the Logical Hardware Resources on
System Bus screen, locate the IOP storage device (the SCSI controller) to which
the 7207 Tape Drive is attached. Type 9 (Resources associated with IOP), then
press Enter.
The Logical Hardware Resources Associated with IOP screen displays with a list of
devices that are configured to the SCSI controller. The 7207 Tape Drive and its tape
controller appear in the list and display a status of Operational.
Are the 7207 tape drive and a tape controller listed under the Storage IOP
column, and is their status operational?
NO Contact your next level of support for further instructions.
YES Exit the System Service Tool to a command line, then continue with Step
23.
Step 23
This step cleans the installed drives and attempts the failing operation again.
Clean the tape drive (refer to the appropriate device chapters in the 7212 Model 102
Storage Enclosure Setup and Operator Guide). Then, attempt the failing operation
again.
Do the installed devices perform the failing operation correctly?
NO Continue with Step 24.
24 7212 Storage Device Enclosure Service Guide

IBM 7212 102 Specifications

General

Brand	IBM
Model	7212 102
Category	Storage
Language	English