IBM 7212 102 User Manual

Chapter 7. Servicing the SLR60 or SLR100 Tape Drive
This chapter describes procedures to follow when a problem is detected with an
installed SLR60 or SLR100 tape drive feature. For additional information about the
status lights, operating features, and rear connections on the SLR tape drive
feature, refer to Chapter 10 in the 7212 Model 102 Storage Device Enclosure Setup and
Operator Guide
Before using or servicing any FRU, let it acclimate to the operating environment
for as long as it has been away from the environment or for 24 hours, whichever is
less.
Handling Static-Sensitive Devices
Attention: Storage devices drives are sensitive to static electricity discharge. To
prevent damage, when handling a storage device drive wrap it in an antistatic bag.
Take the following precautions:
v Do not remove the drive from its antistatic bag until you are ready to install it.
v With the drive still in its antistatic bag, touch it to the metal frame of an
electrically grounded surface.
v Hold the drive by the frame. Avoid touching the solder joints or pins.
v Handle the drive carefully to prevent permanent damage.
Manually Removing a Tape Cartridge
If a power failure or a drive failure prevents the tape cartridge from ejecting, the
cartridge can be removed manually.
Before manually removing the tape cartridge, reset the autoloader to clear potential
error conditions and try all procedures available to remove the tape cartridge. If
the tape does not eject, proceed with the manual removal.
Attention: The procedure that follows may result in damage to your tape
cartridge. If you use this procedure, you must replace the drive. If you choose to
return the drive and the stuck tape to IBM for maintenance, the tape will be
scrapped.
The procedure for removing a tape cartridge varies for the following two
conditions:
v Standby position - with the bridge moved away from the cartridge
v Locked position - with the bridge engaged to the cartridge
To
determine which position the tape unit is in, open the tape unit door and check
the location of the bridge.
To manually remove a tape cartridge:
1. Perform the drive removal procedure. Refer to the 7212 Model 102 Storage
Device Enclosure Setup and Operator Guide.
2. Place the tape drive assembly on a flat work surface and position the drive so
that it faces you.
© Copyright IBM Corp. 2001, 2004 59

IBM 7212 102 Specifications

General

Brand	IBM
Model	7212 102
Category	Storage
Language	English