General Information 1-7
Multimedia
• Onboard 5.25-in. high-performance, eight-speed (8X), twelve-speed (12X),
or sixteen-speed (16X) CD-ROM IDE/AT drive that can read data and play
audio from standard and mini CD-ROM and audio compact discs (audio
CDs). It is compatible with industry-standard multimedia requirements.
• Audio-I/O card (either of with or without wave table feature).
• Fax/modem adapter card with fax send/receive, voice-over-data features,
• One pair of external speakers with power adapter.
• External microphone.
Power management
• Enable/disable power saving feature by BIOS Setup Utility.
• Devices (monitor and hard disk drive) power saving control by BIOS timer
setup.
• System (standby and suspend modes) power saving control by BIOS timer
setup.
Power Supply
• The power supply is a 200-W switchable high/low voltage power supply
with a thermal sensing variable fan speed and a connector for a
detachable grounded 3-wire power cord.
• The power cable has four DASD connectors: one mini power connector
and three standard 4-pin connectors.
• To support the Microsoft Windows 95 software shutdown feature, all power
supplies have a 3-wire auxiliary control cable that connects to the system
board. There is no on/off switch cable assembly for the power supply.
Cables
• Two 40-pin ribbon cable for hard disk drives and CD-ROM
• One 34-pin ribbon cable for diskette drive
• One 3-pin auxiliary power control cable from power supply to system board
• One 4-pin (2-wire) HDD LED cable from system board to front panel
To Next Page
Loading...
Need help?
General