1-8
• One 3-pin (2-wire) power LED cable from system board to front panel
• One 2-pin (2-wire) power switch cable from system board to front panel
• One 4-pin voice signal cable from system board to fax/modem adapter
card
•
One 10-pin and one 34-pin ribbon cable from system board to Audio-I/O
card.
Hard Disk Drive
• The hard disk drive is a 3.5-in. low profile, 1-in. height IDE AT drive with
"look-ahead" 128 KB cache memory and a minimum of 12ms average
seek time. Access time varies by the hard disk drive and the hard disk
drive manufacturer.
Monitors
• 14”(13.1” viewable image size)/15”(13.6” viewable image size) SVGA
(Super Video Graphics Array) monitors include:
− 0.28-mm dot pitch.
− Automatic scanning horizontal frequencies from 30KHz to 54KHz
and all vertical frequencies between 50Hz and 100Hz.
− Up to nine user controls: power, contrast, brightness, horizontal
center, vertical center, horizontal size, vertical size, pincushion
− Auto-sensing power input for 100 Vac to 240 Vac.
− With DDC2A/B feature
− Suspend and off modes with amber indicator blinking.
− Power switch.
− Tilt and swivel base
− Connector for a detachable grounded 3-wire power cord.
− 1.8-m (5.8-ft) attached signal cable.
Keyboard
• 104-key, or 105-key rubber dome keyboard with 1.8-m (6-foot) cable.
Mouse
• PS/2 mouse with 1.8-m (6-foot) cable
To Next Page
Loading...
Need help?
General