IBM Aptiva Series - Page 67

2-14
Table 2- 1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, beeps
Action/FRU
190
Onboard Serial Port 1
I/O Address Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
191
Onboard Serial Port 2
I/O Address Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
192
Onboard Parallel Port
I/O Address Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
193
Onboard Serial Port 1
Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
194
Onboard Serial Port 2
Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
195
Onboard Parallel Port
Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
246
Equipment Confi
g
uration
Error
Ensure the equipment(diskette drive,
hard disk drive, keyboard, mouse, etc.
) are connected properly and are set
correctly in BIOS Setup.
System board