IBM Aptiva Series - Page 66

Check Procedures 2-13
Table 2- 1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, beeps
Action/FRU
182
Onboard Parallel Port
IRQ Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
183
Onboard Diskette Drive
IRQ Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
184
Onboard Pointin
g
Device IRQ Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
185
Onboard IDE Channel 2
IRQ Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
186
Onboard ECP Parallel
Port DMA Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
187
Onboard Diskette Drive
DMA Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
188
Onboard Diskette Drive
I/O Address Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.
189
Onboard IDE Channel 2
I/O Address Conflict(s)
Enter BIOS Setup to execute Load Setup
Default Settings, then reboot system
Remove the non-factory-installed
adapter card and reboot system.