IBM Aptiva Series - Page 72

Check Procedures 2-19
Table 2- 2 Error Symptoms List
Error Symptoms Action/FRU
Hard disk or power-on
indicator LED does not
li
g
ht. The machine
functions normally
otherwise.
Check hard disk LED connector
(CN20) volta
g
es: (See “System
Board Layout” on pa
g
e 5-2.)
CN20 Hard Disk Idle/Accessin
g
pin-1 +5 Vdc / +5 Vdc
pin-2 +5 Vdc / 0 Vdc
pin-3 +5 Vdc / 0 Vdc
pin-4 +5 Vdc / +5 Vdc
HDD LED cable
CD-ROM Drive
Note: Ensure CD-ROM drive confi
g
uration is set correctly in BIOS
Setup, cable/jumper are set correctly and its laser beam is clean
before the any diagnosis of CD-ROM drive problems.
CD-ROM drive LED came
flashin
g
and stayed on
more than 30 seconds
before shutting off.
Software asks to install
disc.
Software displays a
Reading CD error.
CD may have dirt or forei
g
n material
on it, check with a known good disc.
CD is not inserted properly.
CD is damaged.
CD-ROM drive LED does
not flash if a disc is
loaded while system is
powered on and CD-
ROM drive power
connector has the
correct voltage.
CD-ROM drive
CD-ROM drive LED does
not come on but CD-
ROM drive works
normally.
CD-ROM drive