The following illustration shows how to install a switch module in the rear of the
BladeCenter unit.
Switch module
Complete the following steps to install a switch module.
1. Review the information in “Safety” on page ix and “Installation guidelines” on
page 8 through “Handling static-sensitive devices” on page 9.
2. Remove the acoustic attenuation module, if installed, from the rear of the
BladeCenter unit.
Acoustic module
Locking
handle
3. Select a switch-module bay in which to install the switch module.
4. Select a switch-module bay in which to install the switch module, in
accordance with the instructions in “Ethernet interface requirements” on
page 7.
10 IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation and User’s Guide
To Next Page
Loading...
