26
Entry and Exit
Keyboard: Press Ctrl-Scroll Lock or Ctrl-minus (num) to both enter and exit setup.
You can also press F14 or Pause to exit.
For the IBM 3151 emulation, press Ctrl-minus (num) to both enter and
exit setup.
Saving Parameters
Upon exiting setup mode, the prompt “Save All (Y/N)” blinks. Press Y or y to
exit setup and save settings in permanent (nonvolatile) RAM. Press C or c to
cancel the exit request. Press
N or n to exit Setup. The changes will take effect, but will be lost if the
terminal is reset or powered off.
An exception to this is function/edit key and answerback
message programming. Once edited in Setup, the changes are
saved regardless of the way in which you exit Setup.
Movement Inside Menus
F1 through F12: Select the menu that corresponds to the function key. The
Print Screen key accesses the “EXEC” menu. These keys are always active
within Setup. The keys are labeled at the top of each menu.
Cursor Control Keys (↑ ← ↓ →): These keys control movement to parameters
within the menu and is indicated by a highlighted selection bar. This
selection bar will wrap to the other side of the menu at the top, bottom and
side boundaries. For each parameter there are at least two choices. As the
parameter is highlighted, the available choices appear in the area above the
help bar.
Some parameters are action fields and have no choices. See
the Action Fields section later in this chapter.
Enter and Shift-Enter: Cycle “up” or “down” through the choices for a given
parameter.
To Next Page
Loading...
Need help?
General
