44
Send Null Suppress: [Off, On]
♦ Off – Trailing null characters are converted to space characters when
data is sent to the host system.
♦ On – Trailing null characters are removed when data is sent to the host
system.
PRINT: F8
Print Mode: [Normal, Auto, Controller]
Select the way in which printing is controlled.
♦ Normal – indicates that printing is to occur when a print request (such as
print screen) is received.
♦ Auto – prints a line when the terminal receives a LF, a FF, or a VT code,
or when autowrap occurs.
♦ Controller – indicates that host data is sent to the printer (pass through
mode). Printing is controlled by the host computer.
Print Block Term: [<ETX>, <CR>]
Select the character which indicates to the printer that the block of data to
be printed has ended. The options above are for ASCII emulations. In ANSI
emulations, the choices are [None, <FF>].
Print: [National, Line Drawing, Multinational]
Choose the set of characters used when printing.
Print Region: [Screen, Scroll]
Indicate the region of the screen that is to be printed: the entire screen or a
certain section of it called the scrolling region. A scrolling region is a limited
portion of the screen which applications (such as word processors) may
designate to be the user’s region.
Print Line Term: [<US>, <CR><LF>]
Indicate the character that <R> is to terminate a line of print.
Secondary Recv: [Off, On]
When “on,” data received from the serial printer is routed to the port
assigned for the host. This data is not displayed on the screen, and is
transparent to the user. When “off,” data received from the printer port is
ignored.
To Next Page
Loading...
Need help?
General
