51
PROGRAM: F12
F1
Quick
F2
Genrl
F3
Displ
F4
Kybd
F5
Keys
F6
Ports
F7
Host
F8
Print
F9
Emul
F10
Tabs
F11
AnsBk
F12
Prog
Print
Exec
ParametersParameters
Keys = F1 Program = FKey Key Dir = Host
Text: _________________________________________________________________________
_________________________________________________________________________
_________________________________________________________________________
_________________________________________________________________________
Label: _______________ Bytes Remaining: 0542
ChoicesChoices
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12
SelectSelect
↑ → ↓ ← : Parameter
Enter/S-Enter : Next/Prev Choice Exit: Setup Key
Program: [FKey, Sh-FKey, Ctrl-Fkey, Ctrl-Sh-Fkey, Edit Key, Sh-Edit Key]
Specify the type of key to be programmed—function or edit key in its normal
or shifted state.
When Fkey Speed is Fast in the EMUL (F9) menu, the Program options
are F/Key and Sh-F/Key.
Key Dir: [Comm Depend, Host, Printer, Printer & Host, Screen, Host & Screen, Printer & Screen, All]
Select the destination of the contents of the function or edit key. Comm
Dependent will cause the direction of the key data to correspond to the
“Comm Mode” of the current session. For example, if the “Comm Mode” is
Full Block, the contents of the key will be channeled to the screen only. If it
were Full Duplex, then the contents would be sent to the host only.
Text: An edit field which permits up to 255 characters. Once the overall text
limit (up to 542 characters) is reached, the terminal will beep and accept no
more text. If the text is deleted with the backspace key, the default code is
no longer programmed. Shift-Backspace will restore the default. See the Edit
Fields section or “Fkey Speed” in the Emulation section.
To Next Page
Loading...
Need help?
General
